Where To Go From Here - Plextor PX-712 Installation And User Manual

Section 1. Getting Started
• Do not allow moisture or liquids, including water or cleaning fluids,
to touch the drive. Thinner, benzene, or alcohol-based solvents can
mar your drive's surface.
• Do not drop or jolt the drive.
• Do not move, carry or transport a disc in the drive because this can
cause damage.
• Do not attempt to open the drive and service it yourself. Removing
the cover may expose you to harmful electrical voltages or the laser
beam. For your safety, entrust service to experienced service
personnel only.
• Keep your DVDs and CDs free of dirt or other contaminants, by
storing them in jewel cases. Use only industry-standard discs. Do not
insert dirty, warped, poorly balanced, or cracked discs into the drive.
• Do not clean discs using a circular motion. Instead, using a soft, dry
cloth, wipe gently in a radial motion; start at the center of the disc
and proceed to the outer edge.
• Do not attempt to clean your drive using solvent-based cleaners or an
air compressor.
• Do not attempt to clean your drive using a CD cleaning disc. These
discs can damage your drive permanently.

Where to Go From Here

• If you have a PX-712A internal ATAPI drive, see Chapter 2,
beginning on page 9, to install it.
• If you have a PX-712SA internal drive with the new Serial ATA
interface, see Chapter 3, beginning on page 35, to install it.
8
PX-712 Installation and Users Manual