Fluke ScopeMeter 190 II Series 190-104 User Manual page 58

Fluke 190-104, Fluke 190-204
Users Manual
Using Vertical Cursors on a Waveform
To use the cursors for a time measurement (T, 1/T), for a
mVs-mAs-mWs measurement, or for an RMS
measurement of the trace section between the cursors, do
the following:
1 From scope mode, display the
CURSOR
cursor key labels.
2 Press to highlight
F1
that two vertical cursors are
displayed. Markers (—) identify the
selected point where the cursors
cross the waveform.
3 Choose, for example, time
F3
measurement:
4 Choose the trace that you want
F4
the markers to be placed on:
, ,
A B
5 Highlight the left cursor.
F2
6 Move the left cursor to the desired
position on the waveform.
50
. Observe
.
T
, or (Mathematics).
C D M
7 Highlight the right cursor.
F2
Figure 21. Time Measurement with Cursors
8 Move the right cursor to the
desired position on the waveform.
The screen shows the time difference between the cursors
and the voltage difference between the two markers. (See
Figure 21.)
9 Select OFF to turn off the cursors.
F4