Engine Air Cleaner; Drive Belt - Scag Power Equipment SFC-21-5CV Operator's Manual

Section 7
ENGINE FUEL FILTER
Figure 7-3. Fuel Filter

7.4 ENGINE AIR CLEANER

A. CLEANING AND/OR REPLACING AIR
CLEANER ELEMENT
For any air cleaner, the operating environment dictates the air cleaner
service periods. Service and clean the air filter pre-cleaner after every
50 hours of operation. Replace the air cleaner element and pre-cleaner
after every 300 hours or yearly, whichever comes first. Refer to Engine
Owner's Manual.
- NOTE -
In extremely dusty conditions it may be necessary
to check the element once or twice daily to prevent
engine damage.
1. Lift up on the latch securing the air cleaner cover to the air
cleaner assembly. See Figure 7-4.
2. Remove and inspect the air filter. Replace as recommended by
the engine manufacturer. Refer to Engine Owner's Manual.
3. Replace the air cleaner cover and secure.
FUEL SHUTOFF
VALVE

7.5 DRIVE BELT

The transmission drive belt has a fixed idler and should be adjusted after
the first 2, 4, 8 and 10 hours of operation. The belt should be checked
for proper alignment and wear. Thereafter, check the belts after every
40 hours of operation or weekly, whichever occurs first.
If you experience frequent belt wear or breakage,
see your authorized Scag service center for belt
adjustment.
29
ENGINE AIR
FILTER LATCH
ENGINE AIR FILTER
Figure 7-4. Engine Air Filter
- NOTE -
R
ENGINE AIR
FILTER LATCH