Table of Contents
Advertisement
Optical drive
NOTE:
The optical drive spare part kit includes the rear optical drive bracket but does not include the
optical drive cable or cable bracket. The optical drive cable and cable bracket are included in the optical drive
cable kit. See
bracket.
Description
DVD±RW Double-Layer SuperMulti Drive
Optical drive plastic insert (for use in models without an optical drive)
Before removing the optical drive, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the memory module/wireless module compartment cover (see
6.
Remove the hard drive (see
To remove the optical drive:
1.
Remove the Phillips PM2.5×5.0 screw (1) that secures the optical drive to the computer.
2.
Insert a screwdriver or similar small tool into the hole at the rear of the optical drive bay, and then push
the optical drive (2) to release it from the bay.
3.
Remove the optical drive (3) by sliding it out of the optical drive bay.
52
Chapter 4 Removal and replacement procedures
Optical drive cable on page 84
Battery on page
Hard drive on page
for more information about the optical drive cable and cable
36).
49).
Spare part number
689685-001
727614-001
WLAN module on page
45).
ENWW
Advertisement
Table of Contents
