User Interface Controls - Lincoln Electric Aspect 230 DC Operator's Manual

ASPECT ® 230 DC

USER INTERFACE CONTROLS

FIGURE B.3
1. Process Select – Choose between High-Frequency TIG, Touch
Start TIG ® , Soft Stick (7018 electrodes), or Crisp Stick (6010
electrodes).
2. Output Control – Choose 2-Step, 4-Step, or Output On.
3. Sequencer – Allows control of options such as preflow, starting
current, slope, etc.
4. Sequencer Control – Push to cycle through the sequencer
settings.
5. Pulse Sequencer – Can set percent peak current, pulses-per-
second, and percent background current.
6. Voltage Display – Displays the output voltage while welding.
7. Status Lights – Power on, thermal fault, remote, and VRD
enable lights.
8. Amperage Display – Displays the current amperage setting.
9. Memory Display – Shows which of the 9 memory modes is
currently selected.
10. Memory Selection – Ability to save up to 9 welding procedures
and quickly recall them.
11. Exit Menu Button – A quick method to return to amperage
adjustment from anywhere in the menus.
12. Control Knob – Used to set output current and to adjust settings.
Process
This switch allows the user to set the desired process. (See Figure
B.4)
1. High-Frequency TIG
®
2. Touch Start TIG
3. Stick – Soft Mode (7018 style electrodes)
4. Stick- Crisp Mode (6010 Style electrodes)
FIGURE B.4
1
3
Output Control
This switch allows the operator to set the desired output control
method (See Figure B.5). To control the output with 2-step or 4-step,
either a remote trigger (arc start switch) or remote trigger with
amperage control (foot or hand amptrol) may be used.
FIGURE B.5
B-3
OPERATION
2
4