Olarinluoma 9, P. O. Box - Planar C3 Reference Manual

QUICK LINKS
Contents
Index
Regulatory Compliance
Product Information
Warranty
GETTING STARTED
About the Display
Package Contents
Identify Components
Position Display
Desk Stand Features
INSTALLING THE DISPLAY
Set DIP Switch
Install Display Controller
Connect Video and Power
Install Display Driver
Change Display Properties
Dome CXtra Software
APPENDIXES
Troubleshooting
Specifications
LED Status Lights
Single Desktop
USB Connection
Component Removal
Power Management
Palette Options
power supply alone does not represent a functional medical device. Hence, Planar configured
a minimal operating system to exercise the display. The resulting data are made available to
interested parties.
Equipment used outside Canada and the United States may be provided with a non-certified cord,
provided the cord is acceptable to the authorities in the country of usage. Such cords have not
been investigated by CSA and UL and are not part of the certification.
For 120 volt applications, use only a UL-listed detachable power cord with NEMA configuration
5-15P type (parallel blades) plug cap. For 240 volt applications, use only a UL-listed detachable
power supply cord with NEMA configuration 6-15P type (tandem blades) plug cap.
This is informative data, not certification data. Certification data must be obtained by the device or
system integrator according to Article 12 of the MDD titled "Particular procedure for systems and
procedure packs." Paragraph 2 clearly outlines the device or system integrator's responsibility in
this matter.
In summary, Planar Systems, Inc. is CE-marking these displays under the Medical Device Directive,
which establishes compliance to the basic medical safety standards. However, EMC compliance can
only be accomplished in the configured medical device or system and is the responsibility of the
device or system manufacturer. Planar has the necessary documentation such as IEC 60601-1
notified body and other third-party test reports and certifications, a risk/hazard analysis, an
essential requirements checklist, and the Planar International Electrotechnical Commission (IEC)
declaration of conformity.
Planar Systems, Inc., located in Beaverton, Oregon, USA, is the manufacturer of these displays in
the meaning of the directive. As required by the MDD in Article 14, Planar Systems, Inc., not residing
in the European Economic Area (EEA), has a European representative, Planar Systems, Inc.—
Olarinluoma 9, P. O. Box 46, FIN-02201 Espoo, Finland (phone + 358 9 420 01; fax + 358 9 420 0200).
In the opinion of Planar Systems, Inc. registration required to put this device into commerce is the
responsibility of the medical device/system manufacturer, and Planar supports this requirement by
providing a European Commission (EC) declaration of conformity. If Planar supplies a display to an
end user, rather than a device manufacturer, it is the end user's responsibility to ensure continued
compliance with the MDD of the system in which the display is integrated.
For vigilance reporting as required under Article 10 of the MDD, Planar Systems, Inc. will provide
any information requested by competent authority to support any reported incident investigation
by such an authority.
Dome C3i Display
v