Single Desktop - Planar C3 Reference Manual

QUICK LINKS
Contents
Index
Regulatory Compliance
Product Information
Warranty
GETTING STARTED
About the Display
Package Contents
Identify Components
Position Display
Desk Stand Features
INSTALLING THE DISPLAY
Set DIP Switch
Install Display Controller
Connect Video and Power
Install Display Driver
Change Display Properties
Dome CXtra Software
APPENDIXES
Troubleshooting
Specifications
LED Status Lights

Single Desktop

USB Connection
Component Removal
Power Management
Palette Options
Single Desktop
The single desktop mode converts dual Dome C3i displays into one display device
to meet the requirements of some applications. The single desktop mode is
supported on the Dome C3i display in both portrait and landscape modes.
On the display controller, switch 3 on DIP switch must be in the ON position for
each procedure. (See page 7.)
To change the configuration to single desktop
If you are working on a dual-headed display, you can use the following procedure
to change your hardware and software configuration to single desktop.
1 Uninstall any existing DX2 display driver. See "To uninstall the driver" on
page 27.
2 On the DIP switch, place switch 3 in the ON position. (See
3 Reinstall the display controller. (See
the controller. (See page 9.)
4 Power on the system, and run Setup.exe to install the driver. (See
5 Set the display resolution. (See
Dome C3i Display
page 7.)
page 8.) Then attach both displays to
page 11).
page 10.)
23