Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Operating Manual
Advertisement
Table of Contents
Related Manuals for Planar Invitium Tk7
Summary of Contents for Planar Invitium Tk7
- Page 1 ™ Invitium Medical Workstation Tk7 and Tn4 QUICK SETUP GUIDE www.planar.com 020-0276-01A...
-
Page 2: Standard Equipment
Optional Equipment Related documentation Invitium Specification Sheet – Provides computer and display specifications for models Tn4 and Tk7. Refer to the Invitium documentation kit or www.planar.com to obtain this sheet. Invitium Tk7 and Tn4 Operations Manual – Provides detailed instructions on how to set up, use, clean, and troubleshoot the system. -
Page 3: Attach The Mounting Fixture
Attach the Mounting Fixture Install the mounting fixture. (Refer to the vendor documentation.) Attach the Invitium to the fixture using the VESA panel on the back of the Invitium. If the VESA panel on the fixture has slotted upper screw holes, secure the top two screws to the Invitium’s VESA panel, and then slide the Invitium onto the fixture. - Page 4 Tighten the top two screws through the fixture’s mounting plate. Insert and tighten the bottom two screws through the mounting plate. I n vi t i u m Q u i c k S e t u p G u i d e...
-
Page 5: Open The Clamshell
Open the Clamshell Tilt or rotate the Invitium away from the mounting fixture to allow the clamshell to open fully. Note Accessing the connector bay differs depending on the mounting fixture. Loosen the screws on the portion of the clamshell located below the VESA mounting plate on the Invitium. -
Page 6: Connect The Cables
Connect the Cables Connect the keyboard, mouse, and other peripherals. Caution – Electrical hazard PC audio is connected through the video/audio cable. Do not disconnect the video/audio cable or connect another display to this port. Antenna Wireless PC card Power PC card slots ports... - Page 7 Install the PCMCIA wireless network card, if appropriate. Slide the network card into the PC card slot until it locks into place. Attach the gold connectors on the antenna to the two pinholes on the protruding side of the card. NOTE: The Antenna has been tested with the CISCO AIRONET 350 SERIES card and registered with the FCC.
- Page 8 Connect the power adapter. Align the pins on the DC connector with the holes in the power port and push the connector until it locks into place. Caution – Hardware damage Do not force the connector into the power port. The pins may bend if they do not align with the holes.
-
Page 9: Start The Invitium
Start the Invitium Press the power switch to the on (|) position. Adjust the display Brightness Display power Brightness – Press the + or – control to adjust display brightness. Display power – Press the display power button to toggle power on or off. Keyboard light –...