Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Planar Invitium Tk7
Summary of Contents for Planar Invitium Tk7
- Page 1 ™ Invitium Medical Workstation Tk7 and Tn4 OPERATIONS MANUAL www.planar.com...
- Page 2 Planar Systems, Inc. Planar is a registered trademark and Invitium is a trademark of Planar Systems, Inc. IBM is a registered trademark and PS/2 is a trademark of International Business Machines Corporation.
-
Page 3: Regulatory Compliance
U.S. Federal Communications Commission (FCC) Requirements This device was tested and complies with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. - Page 4 European Union Declaration of Conformity for Medical Applications A Declaration of Conformity exists for these products. To obtain a copy, contact Planar and request the “Declaration of Conformity” document number below. • Tk7 – 001-0014-04 • Tn4 – 001-0014-09 Certifications •...
-
Page 5: Warranty Information
Planar’s responsibility to repair or replace defective products is the sole and exclusive remedy provided to the buyer for breach of this warranty. Planar is not liable for any indirect, special, incidental, or consequential damages irrespective of whether Planar has advance notice of the possibility of such damages. -
Page 6: About This Manual
About This Manual Read this manual before you unpack your Planar Chapter 1, Overview Chapter 2, Installing the Invitium Chapter 3, Troubleshooting Audience This manual assumes you have experience installing and using computers. Refer technical issues to your Invitium vendor or system administrator. -
Page 7: Service And Support
Clean the Display Drip protection is in accordance with the IPX1 rating defined in the IEC/EN60529 standard. Dampen a soft cloth with an approved cleaning solution. Wipe the screen lightly until no residue remains. Note Do not spray cleaners directly on the screen. Approved cleaning solutions ... -
Page 9: Table Of Contents
Contents Chapter 1: Overview... 1 Standard Equipment ...1 Optional Equipment ...2 System Configuration...3 Supported Mounting Solutions ...4 Chapter 2: Installing the Invitium... 5 Guidelines...5 Precautions ...6 Attach the Mounting Fixture ...7 Open the Clamshell ...9 Connect the Cables ...10 Start the Invitium ...12 Adjust the Display ...13 Install Additional Software ...14 Chapter 3: Troubleshooting ... -
Page 11: Chapter 1: Overview
Medically certified for patient safety and proximity (UL 2601 and IEC 60601) • Withstands high-impact jarring, ingress of liquids, and hospital-grade disinfectants Standard Equipment Note For specifications, refer to the Invitium Specification Sheet in the documentation kit or posted on www.planar.com/medical/ medical_workstation.asp. ▲ Tk7 only... -
Page 12: Optional Equipment
Optional Equipment Equipment Description Keyboard PS/2 or USB-compliant keyboard. Mouse PS/2 or USB-compliant mouse. Power Adapter External, 12-volt, double-insulated power adapter works from 90 to 240 Vac at 50 to 60 Hz. Equipped with an IEC320 appliance coupler, attached power cable, and U.S. or European medical-grade 3 m power cable. -
Page 13: System Configuration
System Configuration The configuration for some models may differ slightly. Antenna Wireless PC card Power PC card slots ports Central processing unit (CPU) The Invitium uses convection cooling, in which internal thermal management directs heat to an array of cooling vents. Convection cooling eliminates noise and improves reliability. -
Page 14: Supported Mounting Solutions
Supported Mounting Solutions The VESA mounting plate on the Invitium allows the use of standard mounting hardware. VESA FPMPMI-compliant mounting solutions are available through Planar Systems, Inc. Contact your Invitium vendor or visit the Planar web site. www.planar.com/medical/medicalworkstation.asp ▲ Desktop stand ▲... -
Page 15: Chapter 2: Installing The Invitium
Installing the Invitium Guidelines Operating Operate within 32 to 104 Fahrenheit (0 (zero) to 40 Celsius) Store within -4 to 149 Fahrenheit (-20 to 65 Celsius) Allow proper ventilation for sufficient airflow and heat dissipation Mounting Supports 23 lb VESA-compatible, 75 mm or 100 mm pattern Mounting hardware meets the Occupational Health and Safety Administration (OSHA), National Fire Protection Association (NFPA) -
Page 16: Precautions
Precautions Secure all electrical cables. Replacement cables are available from Planar. Firmly grasp the Invitium with two hands and place it in its original packaging when moving it to a different location. Caution – Electrical and fire hazards Install where the temperature range is 32 to 104 Fahrenheit (0 (zero) to 40 Celsius). -
Page 17: Attach The Mounting Fixture
Attach the Mounting Fixture Use four 4 mm 0.7 pitch stainless steel screws of the appropriate length for a tight fit. You need 4 mm of the screw’s threads engaged in the Invitium’s VESA plate for proper support. Install the mounting fixture. (Refer to the vendor documentation.) Attach the Invitium to the fixture using the VESA panel on the back of the Invitium. - Page 18 Tighten the top two screws through the fixture’s mounting plate. Insert and tighten the bottom two screws through the mounting plate. I n vi t i u m O p e r a t i o n s Ma n u a l...
-
Page 19: Open The Clamshell
Open the Clamshell Tilt or rotate the Invitium away from the mounting fixture to allow the clamshell to open fully. Note Accessing the connector bay differs depending on the mounting fixture. Loosen the screws on the portion of the clamshell located below the VESA mounting plate on the Invitium. -
Page 20: Connect The Cables
Connect the Cables Connect the keyboard, mouse, and other peripherals. Caution – Electrical hazard PC audio is connected through the video/audio cable. Do not disconnect the video/audio cable or connect another display to this port. Antenna Wireless PC card Power PC card slots ports... - Page 21 Connect the power adapter. Align the pins on the DC connector with the holes in the power port and push the connector until it locks into place. Caution – Hardware damage Do not force the connector into the power port. The pins may bend if they do not align with the holes.
- Page 22 1 2 I n vi t i u m O p e r a t i o n s Ma n u a l...
-
Page 23: Start The Invitium
Start the Invitium Press the power switch to the on (|) position. Power switch I n s t a l l i n g t h e I n v i t i u m... -
Page 24: Adjust The Display
Adjust the Display Keyboard light Brightness Display power Keyboard light Brightness Press the + or – control to adjust display brightness. Display power Press the display power button to toggle power on or off. Keyboard light Place the keyboard directly under the light. Press the keyboard light to brighten the keyboard during night use. -
Page 25: Install Additional Software
Certified combinations of drivers and applications are available. Contact your Invitium vendor or visit www.planar.com. Attach an external drive to a USB port (no driver is required). Install the software. -
Page 26: Index
Index about the system, 1–4 adapter, power, 2 additional software, installing, 14 adjusting the display, 13 antenna, 10 attaching cables, 9–11 mounting fixture, 7–8 battery pack, 2 brightness, adjusting, 13 carts, medical, 4 certifications, vi clamshell, opening, 9 cleaning solutions, ix cleaning the display, ix components, system, 1 configuration, 3... - Page 27 maintaining the display, ix manufacturer’s declaration electromagnetic emissions, vi electromagnetic immunity, vi medical carts, 2, 4 mounting fixture attaching, 7–8 guidelines, 5 supported, 4 mounting fixtures, 2 mouse, 2 network card, 10 on/off switch, 12 opening clamshell, 9 operating environment, 3 optional equipment, 2, 4 overview, 1–4 PCMCIA card, 10...