Table of Contents
Advertisement
Installing the outdoor camera
1
Open the interface cover (A), and then
slide the power slide switch to ON (B) .
2
Close the interface cover (C).
3
Secure the safety wire ring to the camera
nut of the camera using a driver (D), and
then pass the safety wire through the ring
of the safety wire ring (E).
4
5
1
3
Important:
R Make sure to close the interface
cover securely. Weatherproofness
cannot be assured if the interface
cover is open.
For assistance, please visit http://shop.panasonic.com/support
HN1007_(en_en)_0308_ver.020.pdf
4
Drive the wall mounting screws into the
wall.
1
2
Note:
R Use the following template when
2
29
Longer than 25 mm (1 inch)
1
Space 2.8 mm (
/
inches)
8
1
2
determining the location of the screw
holes.
25.4 mm
(1 inch)
2018/03/07
Setup
29
16:48:50
Advertisement
Table of Contents
