Table of Contents
Advertisement
Camera LED indicators
You can use the LED indicators to confirm the camera's status.
Camera LED indicator
Off
Green or amber, blinking quickly -
off for 1 second
Amber, lit
Green, lit
Green, blinking quickly
Red, lit
Red, blinking quickly
Amber, blinking slowly
Green, blinking slowly
Red, blinking slowly
*1
You can configure the camera so that its LED indicator does not light during normal
operation. For more information, refer to the User's Guide (page 32).
*2
The LED indicator lights in amber for 5 seconds after the power is turned on for the camera.
*3
The signal level (strong, good, weak, out of range) is shown after pressing MSETUPN for 3
seconds.
For assistance, please visit http://shop.panasonic.com/support
HN1007_(en_en)_0308_ver.020.pdf
Status
R No power
R More than 5 seconds have passed since turning on the
power when the camera is not registered to the access
point
R LED indicator is turned off
*1
Camera is on
Not registered to the access point
*3
good
Registration successfully completed or signal level is
*3
strong
Camera is searching for an access point
Registration failed, signal level is weak
*1
motion
*1
Streaming data
Battery is running low
Registration mode, updating
Camera is out of range of the access point
21
*1
*2
, or signal level is
*1
*3
, or detecting
*1
*1
*3
,
2018/03/07
Setup
21
16:48:49
Advertisement
Table of Contents
