Final Installation - Honeywell 51851 User Manual

SECONDARY HANGING SYSTEM INSTRUCTIONS
For installation in the United States: Building codes in the U.S.A. do not require installation of a Secondary Hanging System.
If desired, the braided cable can be cut and removed using wire cutters (sold separately). Skip to FINAL INSTALLATION. For
installation in Canada: In compliance with building codes in Canada, installation of the Secondary Hanging System is required.
1. WARNING: Secondary support is required for this product. Failure to follow the steps below could result in property damage
and/or personal injury. Feed the loop of the braided cable, preassembled to the motor assembly, up through the outlet box
mounted in the ceiling (Figure 4.1).
2. Install secondary support screw, spring washer and support washer partly into the side of the brace installed in the ceiling.
Then loop the braided cable up and over the ceiling brace and place the open loop of the braided cable around the secondary
support screw. Note: The ceiling support brace may not be accessible from below. If not, it must be accessed from above.
Important: The braided cable must make a complete circle around the support brace to secure the fan (Figure 4.2).
3. Tighten the secondary support screw, securing the braided cable (Figure 4.3).
Figure 4.1

FINAL INSTALLATION

1. Use wire connectors and push-in connectors to connect the receiver and fan wires to the supply wires from outlet box
according to the wiring diagram and the following instructions (Figure 5.1):
• Connect the Green wire from the mounting bracket and downrod to the Bare/Green (ground) supply wire.
• Push the White (neutral) supply wire into the empty wire hole of the push-in wire connector preassembled to the White wire
(AC IN N) from the receiver.
• Push the Black (hot) supply wire into the empty wire hole in push-in wire connector preassembled to the Red wire from the
receiver.
WARNING: After the connections have been made, the connected wires should be turned upward and pushed carefully up
into the outlet box. Place the Black and White wire connections on opposite sides of the outlet box.
2. Raise the canopy, ensure the two mounting bracket screws are aligned with the J-shaped slots in the canopy. Then turn the
canopy in a clockwise direction until the mounting bracket screws are completely engaged in the J-shaped slots (Figure 5.2).
3. Install the two previously removed mounting bracket screws in the round holes. Securely tighten all mounting bracket screws
(Figure 5.3).
Bare/Green (ground)
Black (hot)
White (neutral)
Push-in
Connector
3-Pin Connector
(connected to fan wire)
Figure 5.1
Braided Cable
Brace
Figure 4.2
Wire
Connector
Figure 5.2
Open Loop Secondary
Support Screw
Support
Washer
Spring
Washer
Mounting
Bracket Screw
J-Shaped
Slot
EN I 7
Secondary Support Screw
Figure 4.3
Figure 5.3
Mounting
Bracket Screw