Honeywell 51851 User Manual page 8

FINAL INSTALLATION
4. Partially insert three blade screws along with blade washers through the blade, blade arm, and into the medallion. Tighten each
blade screw starting with the one in the middle. Repeat this step for the remaining blades. Note: Ensure the concave edge of the
medallion is parallel to the concave edge of the blade (Figure 5.4).
5. Install the blade arm to the underside of the motor assembly with the motor screws. Tighten each blade arm completely before
moving to the next (Figure 5.5).
6. Remove one of the three fitter plate screws from the fitter plate and loosen the other two but do not remove. Feed the single-
pin connect through the center hole in the light pan. Align the keyhole slots in the light pan with the loosened screws in the
fitter plate. Turn light pan clockwise and replace the previously removed fitter plate screw. Tighten all screws (Figure 5.6).
7. Remove the four light pan screws preassembled to the light pan. Then, connect the single-pin connector from the fan to the
single-pin connector from the light kit -- blue to black and white to white. Secure the light kit with the previously removed
light pan screws (Figure 5.7).
8. Remote control comes equipped with a wall bracket. If you wish to install the wall bracket, remove the small plate to expose
the screw holes. Insert wall brackets screws through holes and into wall, then cover with the previously removed small plate.
The remote can be stored in the wall bracket for easy access (Figure 5.8).
Turn on power to fan at breaker box and the wall switch. Assembly is complete.
Blade Screw
Blade Washer
Blade Arm
Medallion
Figure 5.4
Light Pan Screw
Single Connector
Light Kit
Figure 5.7
Blade
Blade Arm
Figure 5.5
Small Plate
Wall Bracket
Screw
Figure 5.8
Motor Screw
Wall Bracket
EN I 8
Single-pin
Connector
Fitter Plate Keyhole
Screw Slot
Figure 5.6
Light Pan