Final Installation - Honeywell Bonterra User Manual

CLOSEMOUNT INSTRUCTIONS (optional)
1. Remove the canopy cover from the bottom of the canopy (Figure 4.1).
2. Remove the three Phillips-head closemount screws from the top of the motor assembly. Then align the canopy with the holes
in the top of the motor assembly. The larger holes in the canopy will encompass the remaining screws. Secure the canopy to
the top of the motor assembly with the previously removed closemount screws (Figure 4.2).
3. Raise the motor assembly and place the canopy on the hook of the mounting bracket to free hands during the wiring process
(Figure 4.3). Then, insert the receiver from the remote pack into the mounting bracket with the flat side facing the ceiling.
Canopy
Canopy Cover
Figure 4.1

FINAL INSTALLATION

1. Use wire connnectors to connect household supply and receiver wires according to the diagram (Figure 5.1) and the following
steps:
• Connect the green wire from the downrod and mounting bracket to the Bare/Green (ground) supply wire. Note: Closemount
installation does not use the downrod, so there will only be two Green wires to connect.
• Connect the Blue wire with the white label to the blue fan wire.
• Connect the Black wire with the white label to the black fan wire.
• Connect the White wire with the white label to the white fan wire.
• Connect the Black wire with the red label to the Black (live) supply wire.
• Connect the White wire with the red label to the White (neutral) supply wire.
2. Align the canopy over the loosened mounting bracket screws. Place the J-slot of the canopy onto the mounting bracket
screws and rotate clockwise (Figure 5.2).
3. Secure the canopy with the two previously removed mounting bracket screws. Tighten all the mounting bracket screws
securely (Figure 5.3).
Black (hot/power)
Wire Con-
nector
White (neutral)
WARNING: Do NOT wire the
fan motor to a variable-speed
(dimmer) wall control.
Figure 5.1
Canopy
Figure 4.2
Bare/Green
(ground)
Figure 5.2
Mounting
Closemount Screw
Bracket
Figure 4.3
Mounting
Bracket Screw
Figure 5.3
6
Receiver
Hook
Canopy
Mounting
Bracket Screw