19. Feed pull chain through the center hole in the
glass globe, rubber washer and nut. Lift the glass
globe and rubber washer over the threaded rod.
Screw the nut onto the threaded rod to temporarily
hold the glass globe in place. Feed the pull chains
through both holes in the end cap and the center
hole in the finial and lift the end cap up until it is
flush with the glass globe. Screw the finial onto the
threaded rod to hole the light kit in place. (Fig. 19).
20. The pull chain extensions or custom pull chains
extensions (included) may be attached to fan and
light pull chains (Fig. 20).
Light Pull Chain
FINAL INSTALLATION
Fan Pull Chain
12
12
Fig. 19
Rubber
Washer
Nut
End Cap
Finial
Fig. 20
Light
Pull Chain
Fan
Pull Chain