Toshiba MMU-UP0071YHP-UL Service Manual page 101

15
Change "Code (DN)" to [0002] with the [
16
Perform the operation of
data written down in [1] Setting data read out from EEPROM if the setting data is different.
17
After writing down all the data, push the [
At the time, " Setting" is displayed on the screen for a while when the single operation is used, then
the screen returns to the "Field setting menu" screen.
Pushing the [
screen for a while when the group control is used, then the screen returns to the "Field setting menu"
screen.
(It takes approx. 1 min until the remote controller operation is available again.)
* The Code No.(DN) are ranged in order of No., which may be sometimes skipped.
Even after changing the data wrongly and pushing the [
the data before change by pushing the [
<Fig. 2 EEPROM layout diagram>
The EEPROM (IC503) is attached to the IC socket. When detaching the EEPROM, use a tweezers, etc.
Be sure to attach the EEPROM by fitting its direction as shown in the figure.
∗ Do not bend the IC lead when replacing.
EEPROM
14
. Check the other "Code (DN)" also, change "Data" into the setting
Return] button on the unit selection screen again displays "
] / [ ] button. (Filter pollution level)
Return] button.
Menu] button, it is possible to return to
Return] button if the CODE No (DN) is not changed.
- 101 -
Setting" on the
Cut out
EEPROM
Cut out
IC socket