Setting The Speaker Setting; Using The Cut-Off Frequency - Pioneer Super Tuner IIID+ AVH-P7800DVD Operation Manual

Audio Adjustments

Setting the speaker setting

You can make a fine adjustment on each
speaker installed in your vehicle. You can
change the size of each speaker according to
the speaker specification. On a spot at which
a speaker is not installed, you can set the ad-
justment to OFF.
The adjustment you made will be memorized
into this unit and you can recall it.
Recalling speaker settings
% Touch SPEAKER SETTING on the sound
setting menu to select the speaker setting.
Touch SPEAKER SETTING repeatedly to switch
between the following speaker settings:
CUSTOM1—CUSTOM2—CUSTOM3—AUTO
—LAST MEMORY
# You can select LAST MEMORY only when the
adjusted speaker setting is not memorized in this
unit.
# You cannot select AUTO when NETWORK
has been selected. (Refer to Switching the DSP
setting mode on page 117.)
# When STANDARD has been selected, you
cannot select AUTO if auto TA and EQ has not
been carried out.
Customizing the speaker setting
You need to make with/without (or yes/no) and
size (bass reproducing capacity) selection/ad-
justments depending on the installed speak-
ers. The size needs to be set to LARGE (large)
if the speaker is capable of reproducing
sounds of about 100 Hz or below. Otherwise
select SMALL (small).
! Low frequency range is not output if the
subwoofer is set to OFF and the front and
rear speakers set to SMALL or OFF.
! It is imperative that non-installed speakers
be set to OFF.
! Set the front or rear speaker to LARGE if
the speaker is capable of reproducing bass
content, or if no subwoofer is installed.
1 Recall the speaker setting you want to
adjust.
Refer to Recalling speaker settings on this
page.
2 Touch ADJ. next to SPEAKER SETTING
on the sound setting menu.
3 Touch or to select the correct size
for the speaker.
Each time you touch
in the following order:
OFF (off)—SMALL (small)—LARGE (large)
# You cannot select OFF in the front speaker set-
ting.
# You can turn ON or OFF in the subwoofer set-
ting.
# When the rear speaker setting is set to OFF,
the rear center speaker switches to OFF automati-
cally.
Note
You can store the adjusted setting in memory by
using MEMORY. For details concerning opera-
tion, refer to Storing the adjusted audio settings in
memory on page 106.

Using the cut-off frequency

You can adjust the cut-off frequency and slope
to match the characteristics of each speaker
unit. And then you can store the adjusted cut-
off frequency in this unit for later recall.
or it selects the size
En
Section
20
101