Menu operations
7
Touch Start to start auto EQ.
8
When the 10-second countdown starts,
get out of the car and close the door within
10 seconds.
A measurement tone (noise) is emitted from
the speakers, and auto EQ measurement be-
gins.
When auto EQ is completed, Complete is dis-
played.
When the car's interior acoustic characteris-
tics cannot be measured correctly, an error
message will be displayed. (Refer to Under-
standing auto EQ error messages on page 77.)
# It takes about nine minutes for auto EQ mea-
surement to be completed when all the speakers
are connected.
# To stop auto EQ, touch Stop.
# To cancel auto EQ measurement mode during
this procedure, touch the following touch panel
key.
Canceling auto EQ measurement
mode.
9
Store the microphone carefully in the
glove compartment or another safe place.
If the microphone is subjected to direct sun-
light for an extended period, high tempera-
tures may cause distortion, color change or
malfunction.
Note
(AVH-P5200DVD)
Do not press h (eject) to open or close the panel
when you are using the microphone.
Entertainment settings
Selecting the illumination color
This unit is equipped with multiple-color illu-
mination.
Direct selection from preset
illumination colors
You can select an illumination color from the
color list.
1
Display the entertainment menu.
Refer to Introduction of menu operations on
page 54.
2
Touch Appearance.
3
Touch Illumination and then touch a
color on the list.
Customizing the illumination color
1
Display the entertainment menu.
Refer to Introduction of menu operations on
page 54.
2
Touch Appearance.
3
Touch Illumination and then touch
Custom.
4
Display the customizing menu.
Displaying the customizing menu.
5
Touch the color bar to customize the
color.
6
Touch c or d to fine-tune the color.
7
Touch the icon and hold to store the
customized color in the memory.
Storing the customized color in
Memo
the memory.
Section
14
67
En