Ejecting A Disc - Pioneer Super Tuner IIID AVH-P5200BT Operation Manual

Section
04 Basic Operations
— Removing or attaching the front panel
will automatically close or open the LCD
panel. (Refer to page 64.)
! When the ignition switch is turned OFF
after the LCD panel has been closed, turn-
ing the ignition switch ON again (or turning
it to ACC) will not open the LCD panel. In
this case, press OPEN/CLOSE to open the
LCD panel.
! When closing the LCD panel, check to
make sure that it has closed completely. If
the LCD panel has stopped halfway, leaving
it like this could result in damage.
CAUTION
Keep hands and fingers clear of the unit when
opening, closing, or adjusting the LCD panel. Be
especially cautious of children's hands and fin-
gers.
% Press OPEN/CLOSE to open the LCD
panel.
# To close the LCD panel, press OPEN/CLOSE
again.
Adjusting the LCD panel angle
Important
! If you can hear the LCD panel knocking
against your vehicle's console or dashboard,
touch the TILT keys to move the LCD panel a
little forward.
! When adjusting the LCD panel angle, be sure
to touch the TILT keys. Forcibly adjusting the
LCD panel by hand may damage it.
14
En
1 Display the system menu.
Refer to Introduction of menu operations on
page 54.
2 Touch TILT.
3 Touch the TILT keys to adjust the LCD
panel to an easily viewable angle.
The LCD panel angle continues changing as
long as you touch and hold the TILT keys.
Laying the panel down.
Returning the panel to the upright
position.
# As the set angle is saved, the LCD panel will
automatically be adjusted to the same position
the next time the LCD panel is opened.
Turning the LCD panel horizontally
When the LCD panel is upright and hinders
the operation of the air conditioner, the panel
can be turned horizontally temporarily.
% Press and hold OPEN/CLOSE to turn the
LCD panel horizontally.
# To return to the original position, press and
hold OPEN/CLOSE again.
# The LCD panel returns to the original position
automatically, indicated with a beeping sound 10
seconds after operation.

Ejecting a disc

1 Press h (eject).
2 Eject a disc