Rear - Watchguard Firebox T45-PoE Hardware Manual

Firebox T45-PoE Hardware Guide

Rear

Rear view of the Firebox:
Serial Port (Console)
The leftmost port is an RJ45 serial console port. An RJ45 serial cable is not included with the
device.
USB Interfaces
The device includes two USB 3.0 interfaces. Connect a USB storage device for USB backup and
restore, or to store a support snapshot. For more information, see
Network Interfaces
The Ethernet interfaces have standard RJ45 connectors and support link speeds of 10, 100, or
1000 Mbps.
The Firebox T45-PoE has five network interfaces. These interfaces are labeled 0/WAN, 1/LAN, 2,
3, 4/PoE+. Interface 4 is a PoE+ (Power over Ethernet) interface, compliant with the IEEE 802.3at
standard.
Interfaces 1 to 4 only support full duplex connections. Make sure the Firebox
interfaces and network devices you connect to these ports are set to auto-negotiation
or full duplex. Interface 0 supports both half and full duplex connections.
Reset Button
This resets the device. To restore the device to factory-default settings, see
Default Settings
Power Switch
Controls the power supplied to the device. Move the switch to position 1 to power on the device, or
position 0 to power it off.
Power Input
An AC power adapter is included with your device. Connect the AC adapter to the device and to a
power source. Use only the supplied AC power adapter.
11
.
Fireware Help.
Restore Factory-
WatchGuard Technologies, Inc.