Table of Contents
Advertisement
Wall Mount Installation
The optional wall mount plate (available separately) enables you to mount the Firebox on a wall in a good
location to increase the wireless range.
You need four screws 1/8" (3 mm) wide and at least 3/4" (18 mm) long to install the mount plate.
To install the wall mount plate:
1. Place the wall mount plate horizontally against the wall where you want to install the Firebox.
2. Securely screw the wall mount plate to the wall with the four screws.
3. Align the two holes on the bottom of the Firebox with the two connection points on the mount plate.
4. Push the Firebox toward the mount plate, until the two connection points on the mount plate are
inside the holes on the bottom of the Firebox. Then press firmly down to seat the device on the plate.
To remove the Firebox from the mount plate, push the Firebox up slightly, and then pull out, to separate
the connection points on the mount plate from the holes on the bottom of the Firebox.
Restore Factory-Default Settings
If you have a problem in your configuration file that you cannot correct, you can restore the factory-default
settings and start from a new configuration file. For example, if you do not know the administrator account
passphrase, or if a power interruption causes damage to the Fireware OS, you can restore the Firebox to
the factory-default settings and build your configuration again.
To reset the Firebox to factory-default settings:
1. Power off the Firebox.
2. Press and hold the Reset button on the back of the Firebox.
3. Power on the Firebox while you continue to hold the Reset button.
4. Continue to hold the Reset button until the Attn indicator on the front of the Firebox begins to flash.
5. Release the Reset button.
6. Wait until the Attn indicator stays lit and does not flash.
7. Power off the Firebox.
8. Power on the Firebox.
The Firebox restarts with factory-default settings.
WatchGuard Technologies, Inc.
Firebox T45-PoE Hardware Guide
16
Advertisement
Table of Contents
