Rear View - Watchguard Firebox T45-CW Hardware Manual

Rear View

Rear view of the Firebox:
Reset Button
This resets the device. For instructions on how to restore the device to factory-default settings, go to
Restore Factory-Default
SIM Card Slot
To enable a cellular connection as an external interface, insert an activated Nano SIM card. For more
information, go to
Serial Port (Console)
The leftmost port is an RJ45 serial console port. An RJ45 serial cable is not included with the device. For
information on how to connect to the Fireware CLI (Command Line Interface) with the serial port, go to
the Fireware CLI Reference
USB Interface
The device includes one USB 3.0 interface. Connect a USB storage device for USB backup and restore, or
to store a support snapshot. For more information, go to
in Fireware Help .
Restore
Network Interfaces
The Ethernet interfaces have standard RJ45 connectors and support link speeds of 10, 100, or 1000
Mbps.
The Firebox T45-CW has five network interfaces. These interfaces are labeled 0/WAN, 1/LAN, 2, 3, 4.
Interfaces 1 to 4 only support full duplex connections. Make sure the Firebox interfaces and
network devices you connect to these ports are set to auto-negotiation or full duplex.
Interface 0 supports both half and full duplex connections.
Power Switch
Controls the power supplied to the device. Move the switch to position 1 to power on the device, or
position 0 to power it off.
Power Input
An AC power adapter is included with your device. Connect the AC adapter to the device and to a power
source. Use only the supplied AC power adapter.
Antenna Connectors
Connect the antennas to the SMA-type antenna connectors on the rear of the device. For more
information, go to
Settings.
SIM Card Installation.
Guide.
Antenna Installation.
Use a USB Drive for System Backup and