- If the outdoor unit is higher than the indoor unit, prevent rain from flowing into the indoor unit along the connection pipe by making a inverted trap in the connection pipe before it enters
the wall to the indoor unit. This ensures that rain drips from the connection pipe before it enters the wall.
- Piping and the interconnecting wiring are field supplied.
- The illustration above is only a sketch. Different models may be slightly different.
The following units are covered in these installation instructions.
Description
High Wall Heat Pump
Table 1—Parts List
Part No.
1
Indoor Unit
2
Mounting Plate
3
Mounting Screw A ST3.9x25-C-H
4
Anchor
5
Air Filter
6
Wireless Remote Control
7
Wireless Remote Control Holder
8
Wireless Remote Control Mounting Screw B ST2.0x10-C-H