HP ProBook x360 11 G2 Education Edition Manual page 29

9. Swing the front edge of the keyboard/top cover (1) up and back until the webcam module cable,
TouchPad cable, and keyboard cable connectors are accessible.
10. Release the zero insertion force (ZIF) connector (2) to which the webcam module cable is connected,
and then disconnect the webcam module cable from the system board.
11. Release the ZIF connector (3) to which the TouchPad cable is connected, and then disconnect
the TouchPad cable from the system board.
12. Release the ZIF connector (4) to which the keyboard cable is connected, and then disconnect
the keyboard cable from the system board.
13. Remove the keyboard/top cover (5).
Reverse this procedure to install the keyboard/top cover.
Component replacement procedures
HP Confidential
23