Replacing Pulley, Drive Shaft And Ball Bearing - Echo shindaiwa CSG-7410ES Service Manual

CSG-7410ES
EC741S
8-1 Disassembling cutter cover assembly (Continued)
M
U
8-2 Replacing pulley, drive shaft and ball bearing
C
A
D
E
F
G
H
CUTTING SYSTEM
10. Remove cutter cover knob (S).
S
11. Disconnect pipe (M) from pipe connector on
cutter cover assembly.
12. Remove 2 cushions (T) from cutter cover as-
sembly.
13. Remove ring (U) from cutter cover assembly.
T
Removing pulley, drive shaft and ball bearing
B
1. Remove bearing case (A) and slide plate (B)
from cutter cover assembly (Refer to "8-1 Disas-
sembling cutter cover assembly)".
2. Remove 2 pre-coated bolts (C).
3. Insert bar tool into pulley (G) to prevent pulley
rotating.
4. Remove nut (D), disk spring (E), washer (F),
pulley (G) and washer (H).
61