Replacing Cushions And Rear Handle - Echo shindaiwa CSG-7410ES Service Manual

CSG-7410ES
EC741S

6-1 Replacing cushions and rear handle

A
C
A
HANDLE AND CONTROL SYSTEM
C
B
B
D
1. Remove starter assembly, carburetor, cutter
cover assembly, front handle and throttle system
referring to the following section.
Starter assembly; "2-1 Disassembling starter as-
sembly"
Carburetor; "4-5 Removing carburetor, fuel line and
tank vent"
Cutter cover assembly; " 5-2 Inspecting and replac-
Throttle system; "6-2 Replacing throttle system"
2. Remove 3 cusion caps from cushions (A).
3. Remove 2 hex socket head stopper bolts (B)
and slotted head stopper bolt (C).
4. Inspect cushions (A) for wear and cracks. Re-
place with new one as required.
5. Remove 3 cushion caps from cushions (A) and
cushion (D) .
6. Remove 2 hex socket head stopper bolts (B)
and slotted head stopper bolt (C).
7. Inspect cushions (A) and cushion (D) for wear
and crack. Replace with new one as required.
8. Remove rear handle from crankcase.
9. Install rear handle to crankcase with passing
fuel lines through crankcase (Refer to "4-13 Install-
ing carburetor, fuel line and tank vent").
10. Secure rear handle with 4 hex socket head
stopper bolts (B) and 2 slotted head stopper bolt (C)
referring above disassembling steps.
11. Apply approx. 0.5 g lithium-based grease in-
side cushions and then install cushion caps to
cushions.
43
ing belt"