Removing Carburetor, Fuel Line And Tank Vent - Echo shindaiwa CSG-7410ES Service Manual

26
4-5 Removing carburetor, fuel line and tank vent
A
D
C
K
FUEL SYSTEM
B
E
F
G
H
N
M
1. Remove cylinder cover assembly and filter case
(Refer to "4-1 Replacing air filter").
2. Remove 3 pre-coarted bolts (A) and cover stay (B)
3. Remove 2 bolts (C) and bolt (D) from carburetor
elbow.
4. Disconnect pressure line (F) from carburetor el-
bow (E).
5. Remove tank vent (G) from vent line.
6. Disconnect fuel lines, throttle rod and choke rod
from carburetor.
7. Remove starter assembly, cutter cover assem-
bly, front handle and rear handle referring to the
following section.
Starter assembly; "2-1 Disassembling starter as-
sembly"
Cutter cover assembly; "5-2 Inspecting and re-
Rear handle; "6-1 Replacing cushions and rear han-
dle"
7. Remove fuel cap and fuel strainer (Refer to "4-2
Inspecting fuel cap and fuel strainer").
8. Remove fuel line (M), fuel return line (K) and
vent line (N) from rear handle.
CSG-7410ES
EC741S
placing belt"