60
8-1 Disassembling cutter cover assembly
H
K
L
R
Q
N
CUTTING SYSTEM
B
A
C
G
E
F
D
M
J
N
P
1. Loosen tension screw (A).
2. Remove 2 bolts (C) with 13mm socket wrench
and slide pulley cover (B) forward to remove it.
3. Remove cutter cover assembly from unit.
4. Remove bolt (D) with 19 mm socket wrench and
then remove outer frange (E).
5. Remove snap ring (F) using small flat head screw
and then remove collar (G) and inner frange (H).
F
6. Remove 4 pre-coated bolts (J) and cutter cover
plate (K).
NOTE: 8 bolts (L) do not have to be removed.
7. Disconnect pipe (M) from pipe connector on cut-
ter cover assembly.
8. Remove 2 nuts (N) and bolt (P).
9. Remove bearing case (Q) with slide plate (R)
from cutter cover assembly.
CSG-7410ES
EC741S