Cisco Meraki Go GR10 Installation Manual page 7

Table of Contents

Mount the GR10

Attach the GR10 to the Mount Cradle

The GR10 attaches to the mount cradle with two tabs on the cradle that insert into the GR10, and is secured to the

cradle using one screw.

To attach the GR10 to the mount cradle properly, line up the top edge of the AP with the top tab of the mount cradle.

Since the cradle is already mounted to the wall, guide the GR10 towards the top tab and insert the top tab into the

GR10's slot.

Then adjust the GR10 to guide the GR10's bottom slot into the cradle's bottom tab until it clicks into place. Once in

place, the GR10 should be secured to the cradle by using one of the included screws in the cradle's bottom tab.

Table of Contents