Stamina 15-0141R Owner's Manual page 9

ASSEMBLY INSTRUCTIONS
STEP 3
NOTE: The RIGHT PEDAL SHAFT(37) has an R stamped on the end of the pedal shaft. The RIGHT
PEDAL SHAFT(37) has right hand threads and is tightened by turning clockwise. The LEFT
PEDAL SHAFT(41) has an L stamped on the end of the pedal shaft. The LEFT PEDAL SHAFT
(41) has left hand threads and is tightened by turning counterclockwise.
Snap a PEDAL STRAP(39) onto the right PEDAL(38). There are two adjustment holes on each side of
the PEDAL STRAP(39). Select the adjustment holes which allow your feet to be easily removed from the
pedals. Thread the RIGHT PEDAL SHAFT(37) to the RIGHT CRANK(26) as shown. Tighten the pedal
securely. The shoulder of the PEDAL SHAFTS(37, 41) should be in contact with the CRANKS(25, 26)
when securely tightened.
Use the same procedure to attach the LEFT PEDAL SHAFT(41) to the LEFT CRANK(25) and to attach
other PEDAL STRAP(39) to the left PEDAL(38).
STEP 4
NOTE: Refer to the detail view below. Be careful not to damage the SENSOR WIRE(45) on the
METER(31) when disassembling or installing the METER(31).
By hand or by using a simple tool remove the METER(31) from the METER HOUSING(23). Install a
AAA battery into the METER(31), the battery is not included. See page 9 for detailed battery installation
instructions. Press the METER(31) back into the METER HOUSING(23).
Shoulder
9
Shoulder