Table of Contents
Advertisement
R /B Gain
A perture Control
I CR Shoot On/Off
W D On/Off
W D Parameter
D efog On/Off
Custom Preset
As with the position preset function, the camera
shooting conditions can be stored and recalled. The
settings are recalled when the power is turned on.
For setting items, see the "Initial Settings, Custom Preset and Backup"
section on page 26.
User Memory Area
A user area of 16 bytes allows you to write data, such as
an ID for each customer, data for each system, and so
on, freely.
Note
Rewriting of memory is not unlimited. Be careful to avoid using the
memory area for such as unnecessary tasks as rewriting the
contents of the memory for every operation.
Register Setting
The camera's default settings can be changed by the
register setting command.
Register Setting Command:
8x 01 04 24 mm 0p 0q FF
mm: Register No. (=00 to 7F)
pq: Register Value (=00 to FF)
Register Inquiry Command:
8x 09 04 24 mm FF
mm: Register No.
y0 50 0p 0p FF
pp: Register Value
(returned from the camera)
Example: To set communication speed to 38400 bps
8x 01 04 24 00 00 02 FF
After sending this command, turn power off and
back on (power reset) to resume communication
control at 38400 bps.
Example: Sending to confirm settings
8x 09 04 24 00 FF
y0 50 00 03 FF is returned from the camera
The register setting items and No. are as follows.
Baud Rate: 00
Communication speed can be changed.
OSD Language: 60
OSD Language can be changed.
CCD Scanning Mode: 72
CCD scanning mode can be changed.
Digital Output Mode: 73
The FCB camera supports various output modes.
This register "73" allows changing the output
mode.
For details, see "Register Setting" on page 54.
Zoom Limit: 50 (Wide end), 51 (Tele end)
The Wide and Tele zoom limits can be set.
E-Zoom Max: 52
The maximum digital zoom limit can be specified
(default is ×12).
StableZoom: 53
The StableZoom command can be enabled and
disabled with this command.
FocusTrace: 54
When zoom speed is given priority, using the
ZoomDirect command changes focus at high
speed (although the image may be blurred because
focus is not tracked). For example, the focus
transition time from Wide to Tele ends, which
typically takes 2.5 seconds, can be reduced to 1.7
seconds.
FocusOffset: 55
Placing a dome cover in front of the camera may
cause the focal distance of the camera to change.
Especially at the Tele end, this effect exceeds the
AF range, so focus cannot track, although it
responds to changes in this value.
For details, see "Register Setting" on page 54.
Privacy Zone Masking Settings
For details, see page 16.
Motion detection
For details, see page 20.
Title Display
Y ou can set a title composed of up to 11 lines. One
line can contain up to 20 characters.
Y ou can set display on/off, the horizontal position of
the first character, blinking state and color for each
line.
T he camera gives priority to lines of a title when the
camera status is displayed on the relevant line. On the
lines where a title is not set, the camera status is
displayed.
Line Number
H-position
Blink
Color
Basic Functions
00 to 0A
00 to 17
00: Does not blink
01: Blinks
00
White
01
Yellow
02
Violet
03
Red
04
Cyan
05
Green
06
Blue
1
Advertisement
Table of Contents
