Finishing The Outdoor Unit Installation; To Check The Insulation Resistance Of The Compressor; Configuration; Overview: Configuration - Daikin EBLA08E23V3 Installation Manual

e Wires between the relays and X10M (AWG18 RED)
X5M
5 6 9 10
b b
1 2 3 4
X10M
K2A
a K1A b
2 Connect the low voltage wiring as follows:
S4S Smart Grid pulse meter (optional)
180°
3 Connect the high voltage wiring as follows:
1
High voltage Smart Grid contact 1
2
High voltage Smart Grid contact 2
EBLA04~08E2V3+E23V3 + EDLA04~08E2V3+E23V3
Daikin Altherma 3 M
4P685229-1D – 2022.10
X5M.4
S4S
X5M.3
X5M
13 14
3 4
X10M.1
L
1
X10M.2
N
X10M.3
L
2
X10M.4
N

7 Finishing the outdoor unit installation

180°
4 Fix the cables with cable ties to the cable tie mountings. If
necessary, bundle excessive cable length with a cable tie.
7 Finishing the outdoor unit
installation
7.1 To check the insulation resistance
of the compressor
NOTICE
If, after installation, refrigerant accumulates in the
compressor, the insulation resistance over the poles can
drop, but if it is at least 1 MΩ, then the unit will not break
down.
▪ Use a 500 V mega-tester when measuring insulation.
▪ Do NOT use a mega-tester for low voltage circuits.
1 Measure the insulation resistance over the poles.
If
≥1 MΩ Insulation resistance is OK. This procedure
is finished.
<1 MΩ Insulation resistance is not OK. Go to the
next step.
2 Turn ON the power and leave it on for 6 hours.
Result: The compressor will heat up and evaporate any
refrigerant in the compressor.
3 Measure the insulation resistance again.
8

Configuration

INFORMATION
Cooling is only applicable in case of reversible models.
8.1

Overview: Configuration

This chapter describes what you have to do and know to configure
the system after it is installed.
NOTICE
This chapter explains only the basic configuration. For
more detailed explanation and background information,
see the installer reference guide.
X10M
1 2 3 4
Then
Installation manual
29