Function Setting; Function Selection Mode; Default Setting - SMC Networks ISE80 Operation Manual

Function Setting

■Function selection mode

In measurement mode, press the
Select to display the function to be changed, [F
Press the button for 2 seconds or longer in function selection mode to return to measurement mode.
∗: Some functions are not available depending on part number. All functions are displayed with [F
description. If a function is not available, the function is displayed as [- - -].

■Default setting

At the time of shipment, the following settings are provided.
If this condition is acceptable, then keep these settings.
To change the settings, enter function selection mode.
•[F 0] Units selection function
Symbol
Nil or M
P
•[F 1] Setting of OUT1
Item
Output mode Select hysteresis mode or window comparator mode.
Reversed output Select reversed output.
Pressure setting Set the ON or OFF point of the switch output.
Hysteresis Set the hysteresis to prevent chattering.
Display colour Select the display colour.
button for 2 seconds or longer to display [F 0].
Page 23
Model Default setting
ISE80(H) MPa
ZSE80(F) kPa
ISE80(H)
psi
ZSE80(F)
Page 24
Description
].
-21-
] followed by the function
Default setting
Hysteresis mode
Normal output
ISE80: 0.500 MPa
ZSE80: -50.5 kPa
ZSE80F: 50.0 kPa
ISE80H: 1.000 MPa
ISE80: 0.050 MPa
ZSE80: 5.1 kPa
ZSE80F: 5.0 kPa
ISE80H: 0.100 MPa
ON: Green
OFF: Red
No.PS※※-OMM0003-J