Table of Contents
Advertisement
Do not throw old battery into fire.
≥ Heating a battery or throwing it into a fire may
result in an explosion.
If the operating time is very short even after
the battery has been recharged, the battery
has worn out. Please purchase a new
battery.
About the AC adaptor
≥ If the temperature of the battery is extremely
high or extremely low, charging may take time
or the battery may not be charged.
≥ If you use the AC adaptor near a radio, radio
reception may be disturbed. Keep the AC
adaptor 1 m (3.3 feet) or more away from the
radio.
≥ When using the AC adaptor, it may generate
whirring sounds. However, this is normal.
≥ After use, be sure to disconnect the AC cable
from the AC outlet. (If you leave this unit
connected, the AC adaptor will consume
approximately 0.3 W.)
≥ Always keep the electrodes of the AC
adaptor and battery clean.
≥ Install the device near an AC outlet so
that the power disconnection device
(AC mains plug) can be accessed
easily by hand.
About charging lamp during
charging
When the charging lamp is flashing, the
following should be considered.
Flashing with approx. 4 second period (off
for approx. 2 seconds, on for approx.
2 seconds):
≥ When the battery is over discharged or the
temperature of the battery is too high or low.
It can be charged, but it may take a few hours
to complete the charging normally.
≥ Once normal charging starts, the charging
lamp lights up green. However, depending on
the conditions of use, even when normal
charging is taking place, the charging lamp
may keep flashing in approx. 4 second
intervals until charging is completed.
Flashing with approx. 0.5 second period (off
for approx. 0.25 second, on for approx.
0.25 second):
≥ The battery is not charged. Remove the
battery from the unit, and try charging again.
≥ Check that the terminals of the unit or battery
are not dirty or covered with a foreign object,
and connect the battery correctly once again.
If a foreign object or dirt is present, turn off
the unit before removing.
≥ The battery or environment is at an extremely
high or low temperature. Wait until the
temperature has returned to an appropriate
level and try charging again. If you are still
unable to charge, there may be a fault in the
unit, battery or AC adaptor.
Off:
≥ Charging has finished.
≥ If the status indicator stays off despite the
charging being unfinished, there may be a
fault in the unit, battery or AC adaptor. Refer
to page
8
for details on the battery.
About the SD card
When disposing of or giving away the SD
card, note that:
≥ Formatting and deletion of this unit or
computer only changes the file management
information and does not completely delete
the data in the SD card.
≥ It is recommended that the main SD card is
either physically destroyed or the SD card is
physically formatted using this unit when
disposing of or giving away the SD card.
≥ To physically format, connect this unit to the
AC adaptor, select [OTHER FUNCTION] #
[FORMAT MEDIA] # [SD CARD 1] or [SD
CARD 2] from the menu, and touch [YES].
Press and hold recording start/stop button in
the following screen for three seconds.
Screen to delete the SD card data is
displayed, so select [YES] and follow the
instruction on the screen.
- 9 -
Advertisement
Table of Contents
