Panasonic HC-MDH3 Owner's Manual page 51

∫ To change the peaking settings
If you set Focus Assist to ON by following either of the
procedures below, in-focus portions are highlighted with
color (Peaking G).
j Setting the menu item [FOCUS ASSIST 1] to
[PEAKING] or [BOTH] and pressing the USER button
to which <FOCUS ASSIST 1> is registered.
j Setting the menu item [FOCUS ASSIST 2] to [PEAKING] and pressing the USER button to
which <FOCUS ASSIST 2> is registered.
≥ You can set the peaking color and strength.
(When changing the peaking color)
Select the menu.
MENU
: [SW SETUP] # [PEAKING COLOR] # desired color
[Red]/[Blue]/[Yellow]/[White]
(When setting the peaking strength)
1 Select the menu.
MENU
: [SW SETUP] # [PEAKING LEVEL] # desired setting
2 Touch /
≥ You can select a value between s7 and r7.
3 Touch [EXIT] to complete the setting.
(Notes on Focus Assist)
≥ Focus Assist is not possible in following cases:
j During Recording Check
j During Freeze Frame
j When color bars are displayed.
≥ Focus Assist is canceled in following cases:
j If you turn the unit off
j When the mode switch position is changed
j (If you operate the USER button to which <FOCUS ASSIST 1> is registered)
When the setting of [FOCUS ASSIST 1]
j (If you operate the USER button to which <FOCUS ASSIST 2> is registered)
When the setting of [FOCUS ASSIST 2]
j When you set this unit to Auto Focus
≥ The magnified display and peaking are not displayed on recorded images.
≥ The magnified display and peaking are not displayed on a TV.
≥ Freeze Frame is not available when you use Focus Assist.
≥ Peaking may not be displayed when you use Digital Zoom
the same time, we recommend increasing the magnification level of the magnified display by
setting [FOCUS ASSIST 1] to [BOTH] or by using the magnified display and the peaking function
in combination.
to adjust settings.
(l 71)
(l 72)
(l 83)
(l 50) is changed
(l 50) is changed
(l 72)
(l 70). To zoom in and use peaking at
- 51 -
