Table of Contents
Advertisement
About this task
The following image(s) indicate the location of the power button and provides a visual representation of the installation
procedure.
Steps
1. Slide the power-button cable through the slot on the front of the chassis.
2. While pressing the tabs on the power button insert it through the slot on the chassis and then secure it into place.
3. Connect the power-button cable to the system board.
4. Place the computer in an upright position.
Next steps
1. Install the
hard
drive.
2. Install the
front
cover.
3. Install the
left-side
cover.
4. Follow the procedure in
Graphics card
Removing the graphics card
Prerequisites
1. Follow the procedure in
2. Remove the
left-side
About this task
NOTE:
Depending on the configuration ordered, your computer may not have a discrete graphics card installed.
The following image(s) indicate the location of the graphics card and provides a visual representation of the removal procedure.
24
Removing and installing components
After working inside your
Before working inside your
cover.
computer.
computer.
Advertisement
Table of Contents
