Assembling The Oil Pump And Screen; Air Intake System - Removal; Assembling The Intake System - Husqvarna 140 Workshop Manual

Repair instructions

7.12 Assembling the oil pump and screen

1
Fit the chain guide plate with tightening torque
1–1.5 Nm.
Fit the drive gear, needle bearing, clutch drum and
the clutch (min. 20 Nm).
Fit the chain, bar and clutch cover.
WARNING!
Poor chain lubrication can result
in failure of the chain, which could
cause serious or fatal injury.
7.13 Air intake system – removal
The air intake system comprises:
• intake manifold (A)
• plastic partition wall (B)
• rubber partition wall (C)
(see figure 21)
1
Now loosen the screws using tool 502 50 87-01..
Fig 21
32
– English
7.14

Assembling the intake system

1
Fit the intake manifold (A) and the partition walls
(B and C) on the cylinder using tool 502 50 87-01
(see figure 21).
Cleaning and inspection
Clean and check all parts carefully. Parts must be
replaced if cracked or show signs of other defects.
Always use original spare parts.