Table of Contents
Advertisement
Setting the four preset VMD areas
Setting VMD areas divided in 4 areas for each outline colour.
Important
• The VMD alarm detect function may not work while the settings are being updated on the setup page.
• Alarm setup page
1
3
4
1
2
3
2
4
5
5
6
6
Click the [VMD area] tab on the "Alarm setup" page.
Drag the mouse across the image and select the
area. Clicking the [All Areas] button selects all areas
and surrounds them with a white frame.
Change [Status] for the outline colour to set as a
VMD area to [ON].
Select "High/Middle/Low" for [Detection sensitivity].
The detection sensitivity set here is common to all
areas.
Click the [Setup] button.
The settings are reflected.
To turn a VMD area OFF, change the [Status] setting
for the corresponding area to OFF.
When the [SET] button is clicked after selecting
[OFF], the outline colour will be indicated as a broken
line. No alarm operation will be performed even when
motion is detected in an area whose [Status] setting
is OFF.
42
Advertisement
Table of Contents
