Installation; Color Sip Cordless Phone - Ls-S3410/Ls-S3410-Usb/Ls-S3420/Ls-S3420-Usb - VTech LS-S3410 User Manual

Installation

Color SIP Cordless Phone - LS-S3410/LS-S3410-USB/LS-S3420/LS-S3420-USB

Telephone base installation
1. Plug a Cat-5 network cable into the RJ-45 LAN port on the telephone base and the network wall jack with Power over Ethernet
(PoE).
2. Once installed, the telephone base begins the following initialization and system registration process.
a. All LED lights turn on, and then go off.
b. The base will retrieve the IP assigned to it. There will not be LED indication when the IP is assigned.
• If there is no IP assigned to the base, the MUTE LED will flash green slowly.
c. The base will import the provisioning configuration. The MUTE LED and the SPEAKER LED will toggle quickly while importing.
• If there is no import of the provisioning configuration, there will not be LED indication.
d. The base will initiate the firmware upgrade. The MUTE LED and the SPEAKER LED will toggle quickly during the firmware upgrade.
• If there is no firmware upgrade, there will not be LED indication.
e. The base will register for the SIP account. All LED will go off after SIP account registration.
• If there is no SIP account registered, both the MUTE LED and the SPEAKER LED will flash green quickly.
NOTE: For LS-S3410-USB, you need to plug in the power adapter to the base and a standard wall jack, so that the add-on charging port
can function.
CAUTION:
Use only the supplied Cat-5 network cable. Cat-5 network cable is not designed for use in any other IT devices. Misuse of Cat-5 network cable on your
other IT devices shall be prohibited. To order a replacement, call 1-888-907-2007.
Network wall jack
with Power over
Ethernet (PoE)
Cat-5 network cable
To RJ-45 LAN port
5