LG A9T Series Owner's Manual page 30

OPERATION
30
NOTE
• When cleaning with steam, press the steam
button to turn off the steam mode and use the
a
product in normal mop mode.
• The steam cools and can condense into water
droplets, which can drip when the nozzle is
turned upside down or stored. This is not a leak,
so use it with confidence.
Drying the Water Tank and Mop
Pads
Drying the Water Tank
When cleaning is completed, make sure to empty
the water tank and allow it to dry before storing the
steam mop nozzle.
WARNING
• After cleaning, separate the mop pads from the
steam mop nozzle after letting it cool sufficiently.
Touching the steam mop nozzle or the mop pads
before they are sufficiently cooled may result in
burns.
CAUTION
• Turn the water inlet caps to make sure they
remain open when storing the water tank. If
caps are closed and not properly dried, it may
cause odour.
• Do not remove the water inlet caps from the
water tank as the rubber caps may tear or break.
• Do not pull or stretch the rubber gasket on the
water supply inlet. Doing so may tear or damage
it.
• Do not add detergent, vinegar or baking soda to
the water tank when washing it. Residues from
these chemical agents are not easily removed in
the water tank, which may soil the floor.
• After cleaning, gently wipe off any remaining
water on the water supply inlet
mop nozzle with a soft cloth. The water could
drip onto the floor and damage it.
1
Open the 2 water inlet caps
the water tank and empty the water tank.
Shake the water tank to remove the remaining
water. Do not tap the water tank against any
surface.
2
Leave the water inlet cap open and allow the
water tank to dry in a well-ventilated area out
of direct sunlight for at least 24 hours.
on the steam
a
on the side of
a