Bissell CROSSWAVE PET 2328 Series Manual page 11

Maintenance:
WARNING
To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect plug from
electrical outlet before performing maintenance or troubleshooting.
1
To release dirty water
tank, press down on
recessed button on the
top of the dirty tank.
Did You Know?
The Float is what prevents your dirty tank from overflowing. When your dirty
tank is full, the float will shut off your suction motor creating a high pitched
sound indicating it is time to empty your dirty water tank.
4
Remove strainer from dirty
tank then throw debris in trash.
7
Hand wash the vacuum filter and screen with
warm water and mild detergent.
Dirty Water Tank
2
Grab the front handle while
pressing down on button and
pull dirty water tank away from
the unit.
5
Pour dirty water out. Rinse the
inside of the dirty water tank.
3
Grasp top of dirty water tank
in recessed areas on each side
of the filter and pull upward to
remove the top of the tank.
6
Remove the filter from the
top of the dirty water tank
by pulling it up.
8
Rinse the float located at the bottom of the
top of the dirty water tank.
www.BISSELL.com
11