Honda Deluxe 2014 Manual page 134

Tire Puncture u
2. Align the end of the rear axle shaft with
the surface of the swingarm.
Surface of
swingarm
End of rear
axle shaft
3. Tighten the rear brake caliper stopper
bolt.
Torque: 51 lbf·ft (69 N·m, 7.0 kgf·m)
4. Tighten the rear axle pinch bolt to hold
the rear axle shaft.
5. Tighten the rear axle nut.
Torque: 72 lbf·ft (98 N·m, 10.0 kgf·m)
132
Removing Wheels
Rear axle shaft
6. Lower the rear wheel on the ground.
7. Loosen the rear axle pinch bolt.
8. Pump the swingarm up and down to seat
the axle by pushing the rear end of the
seat several times.
9. Tighten the rear axle pinch bolt.
Torque: 20 lbf·ft (27 N·m, 2.8 kgf·m)
10. After installing the wheel, apply the
brake pedal several times, then recheck
that the wheel rotates freely. Recheck
the wheel if the brake drags or if the
wheel does not rotate freely.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.