Name Of Parts - Fujitsu AOY7FSAC Operating Manual

NAME OF PARTS

Fig. 1 Indoor Unit
1 Operating Control Panel (Fig. 2)
2 POWER Switch
3 MANUAL AUTO button
4 Remote Control Signal Receiver
5 Indicator Lamps (Fig. 3)
6 OPERATION Indicator Lamp (red)
7 TIMER Indicator Lamp (green)
G
If the TIMER indicator Lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See Page 14 Auto Restart).
8 SWING Indicator Lamp (orange)
9 Intake Grille (Fig. 4)
0 Air Filter
A Air Flow Direction Louver
B Right-Left Louvers
(behind Air Flow Direction Louver)
C Drain Hose
D Power Supply Plug
E Power Supply Cord
F Air Cleaning Filter (optional)
Fig. 5 Outdoor Unit
G Intake Port
H Outlet Port
I Pipe Unit
G
Refer to the fold-out page on the cover.
En-3
Fig. 6 Remote Control Unit
J SLEEP button
K MASTER CONTROL button
L SET TEMP./SET TIME buttons (
M Signal Transmitter
N TIMER button
O FAN CONTROL button
P START/STOP button
Q AIR FLOW DIRECTION button
R SWING LOUVER button
Rear side (Fig. 7)
S TIME ADJUST button
T ACL button
(located inside battery compartment)
U TEST RUN button
G
This button is used when installing the con-
ditioner, and should not be used under nor-
mal conditions, as it will cause the air con-
ditioner's thermostat function to operate in-
correctly.
G
If this button is pressed during normal op-
eration, the unit will switch to test opera-
tion mode, and the Indoor Unit's OPERA-
TION Indicator Lamp and TIMER Indicator
Lamp will begin to flash simultaneously.
G
To stop the test operation mode, either
press the TEST RUN button once again, or
press the START/STOP button to stop the
air conditioner.
V Remote Control Unit Display (Fig. 8)
W Transmit Indicator
X Clock Display
Y Operating Mode Display
Z Timer Mode Display
[ Fan Speed Display
\ Temperature Set Display
] Timer Set Indicator
^ Temperature Set Indicator
)