13. Connect the I/O-board cable to the system board.
14. Adhere the tape that secures the I/O-board cable to the system board.
15. Close the right display hinge.
16. Replace the three (M2.5x4) screws that secure the right display-hinge to the palm-rest and keyboard assembly.
Next steps
1. Install the
heat
sink.
2. Install the fan.
3. Install the
wireless
card.
4. Install the
M.2 2280 solid-state drive
5. Install the
M.2 2230 solid-state drive
6. Install the
memory
module.
7. Install the
3-cell battery
8. Install the
base
cover.
9. Follow the procedure in
Power-adapter port
Removing the power-adapter port
Prerequisites
1. Follow the procedure in
2. Enter
Service
Mode.
3. Remove the
base
cover.
About this task
The following images indicate the location of the power-adapter port and provide a visual representation of the removal
procedure.
58
Removing and installing components
or
M.2 2230 solid-state drive
in M.2 slot two, if applicable.
or
4-cell
battery, whichever applicable.
After working inside your
Before working inside your
in M.2 slot one, whichever applicable.
computer.
computer.