Table of Contents
Advertisement
④ Connecting to the node or room you have most recently connected
1. If you have previously connected to a node ID or a room ID on the Internet, it
appears in gray at the bottom of the screen.
• Press the PTT switch or touch the ID to connect to the previous connection
destination. When you connect, the connection destination is displayed in
white.
• If connection is unsuccessful, an error message appears and the name flash-
es again.
⑤ Entering the DTMF ID number (5 digits) of the node or the room
1. Press and hold the [#] key on the microphone.
Displays the DTMF ID input screen.
2. Enter the 5-digit DTMF ID.
3. Press the [#] key on the microphone to start a connection.
• Once connection is successfully established, "Connected" will appear on the LCD.
• If connection is unsuccessful, an error message appears and the screen returns to the DTMF ID input
screen.
• Press the [ ] key on the microphone to cancel the DTMF input screen.
FTM-300D/FTM-200D
There are five ways to connect to a digital room or a digital node on the Internet.
① Searching from the node & room lists (page 42)
② Searching the node ID or the room (page 43)
③ Selecting the node or the rooms registered in the category list (page 43)
④ Connecting to the node or room you have most recently connected (page 44)
⑤ Entering the DTMF ID number (5 digits) of the node or the room (page 44)
Another C4FM digital transceiver accessing the portable node frequency and using the WIRES-X DG-ID number may
also connect a node or a room. For details, refer to the Operating Manual (WIRES-X Edition) of each transceiver.
① Searching from the node & room lists
1. When the local node is displayed in the upper row, rotate the DIAL knob to
select [SEARCH & DIRECT] and press the DIAL knob.
Displays the category list.
2. Rotate the DIAL knob to select [ALL] and press the DIAL knob.
Displays the list of accessible nodes and rooms.
• Connection destinations are displayed from the room list and then node list.
• On the connection destination room columns, the number of activities (the
number of nodes connected to each room) appears on the right side.
3. Rotate the DIAL knob to select a node or room and press the DIAL knob to start
connection.
By pressing the PTT switch, you may also establish the connection while talking.
Once connection is successfully established, "Connected" will appear on the LCD.
If connection is unsuccessful, an error message appears and the screen returns
to the list of nodes and rooms.
42
JQ1YBG-ND Shinagawa-
SEARCH & DIRECT
CATEGORY
ALL
SEARCH & DIRECT
C1:
C2:
C3:
C4:
[ALL LIST]
999
CQ-JAPAN
123
JA1YOE-TKY-ROOM
42
JA1YOE-ROOM-A
31
JA1YOE-ROOM-B
16
CQ-AMERICA
CQ-EUROPE
8
2
Advertisement
Table of Contents
