Yaesu WIRES-X TM-400XDE Instruction Manual page 25

Function
Reverses the transmit and receive frequencies
Squelch OFF
Adjusts the squelch level
Switches Busy detection between "Noise squelch" and "DG-ID number match". Press and hold the A/B(DW) key
*
Some setting items in the set mode are automatically set for the Portable Digital Node function, so these settings cannot be used.
2. Setting the transmit and receive DG-ID number.
This procedure is unnecessary if the transceiver is already set to the required transmit and receive DG-ID
number.
Since the transmit and receive DG-ID number is "TX: 00" and "RX: 00", it operates as an open node and is
accessible from all transceivers using C4FM digital mode.
When using a portable node station to be accessed only by the specific members, set the transmit and receive
DG-ID to a number other than "00".
• In the Access Point, if the receive DG-ID is set to other "00", set the
number. Note that setting to a different number will not work properly.
• When setting the receive DG-ID number to "00" and then setting the transmission DG-ID number to anything other
than "00", the audio of all received C4FM digital stations will be heard on the speaker, but for the transmission DG-
ID Only the matched communication is relayed to the opposite station on the Internet.
• The DG-ID Subcode cannot be used or set in Portable Digital Node mode.
 FT5D
1. Press the [F menu ] key, and touch [DG-ID].
• If [DG-ID] is not displayed, touch [BACK
he DG-ID SETUP screen is displayed on the LCD.
• T
2. Press the [F menu ] key, then rotate the DIAL knob to set the transmit DG-ID
(DG-ID TX).
When setting the DG-ID number, pressing and holding the [GM/X] key will set
the transmit and the receive DG-ID numbers to "00".
3. Press the [F menu ] key, then rotate the DIAL knob to select "DG-ID RX".
4. Press the [F menu ] key, then rotate the DIAL knob to set the receive DG-ID (DG-ID
RX).
5. Press the [BACK] key or the PTT switch to save the setting and return to the
normal operation.
The setting of the FT5D transceiver is complete.
Key or Dial
Press and the P1 key ~ P4 key on the microphone*
*Setting of "REVERSE" function is necessary for P1
~ P4 keys in set mode.
Press the P1 key on the microphone (by default setting)
Press the SQL(VOICE) key, then rotate the DIAL knob
] to display [DG-ID] and then touch it.
24
transmit
DG-ID number to the same DG-ID
DG-ID TX : 00
DG-ID RX : 00
DG-ID TX : 50
DG-ID RX : 00
DG-ID TX : 50
DG-ID RX : 00
DG-ID TX : 50
DG-ID RX : 50