Honda CBR600RR 2009 Owner's Manual page 24

Lamp Check
The low oil pressure indicator comes on
when you turn the ignition switch ON so
you can check that it is working. The
indicator remains on until after the engine
is started.
The neutral indicator, high beam indicator,
left turn signal indicator, right turn signal
indicator, and high coolant temperature
indicator light for a few seconds and then
go off when you turn the ignition switch
ON.
The PGM-FI malfunction indicator lamp
(MIL) and HESD indicator light for a few
seconds and then go off when you turn the
ignition switch ON and engine stop switch
is at RUN.
Gauges, Indicators & Displays
(CBR600RR ABS only)
The Combined ABS indicator comes on
when you turn the ignition switch ON.
This indicator goes off after you ride the
motorcycle at a speed above 6 mph (10
km/h).
When applicable, the high beam and
neutral indicators come on when you turn
the ignition switch ON and remain on until
you select the low beam or shift out of
neutral.
These indicators are identified in the table
−
on pages 18
Check.
If one of these indicators does not come
on when it should, have your Honda dealer
check for problems.
Instruments & Controls
21 with the words: Lamp
15