Sewing preparation
threading the upper thread
1
2
4
3
changing the needle
22
⦁
raise the needle and presser foot
⦁
turn power switch to «0» (off)
⦁
place foam pad on the spool pin
⦁
place spool on pin so that the thread unwinds clockwise
⦁
attach appropriate spool disc
⦁
hold the thread and lead it from the bobbin along the direction of the arrow
into the rear guide 1
⦁
then into slit of upper thread tension 2
⦁
pull thread down to the right of the take-up cover and around 3
⦁
take thread up to the left of the cover and around 4, placing it in the take-up
lever
⦁
take thread down and through guides 5 and 6
⦁
thread the needle (see page 24)
5
6
removing the needle
⦁
raise the needle
⦁
remove or lower presser foot (see page 24, 30)
⦁
turn power switch to «0» (off)
⦁
loosen the needle clamp screw 1 using the gray screwdriver
⦁
pull the needle down to remove
Inserting the needle
1
⦁
flat side of needle to the back
⦁
insert the needle as far as it will go
⦁
tighten needle clamp 1 using the gray screwdriver
033805.51.04_2014-02_Manual_B710_EN
appropriate spool disc
Diameter of thread spool determines disc size. There must be no
gap between the disc and the spool.