Download Print this page

Safety System Tests - Snapper H1528ES Operator's Manual

Advertisement

Available languages

Available languages

Safety Decals
Before operating your unit, read the safety decals. Compare
Figure 1 with the table below. The cautions and warnings are
for your safety. To avoid a personal injury or damage to the
unit, understand and follow all the safety decals.
WARNING
If any safety decals become worn or damaged, and
cannot be read, order replacement decals from your
local dealer.
1
A
B
A
Chute Danger
Decal
(P/N 1737865)
B
Auger Danger
Decal (large-
frame models)
(P/N 1737866)
C
Auger Danger
WARNING
Decal (small-
frame models)
(P/N 1752919
- Warning;
1752422 -
Danger)
C
AVERTISSEMENT
DANGER

Safety System Tests

Determining Which Test to Use
Please select the appropriate Safety System Test for your
unit:
Models without Free Hand™ Control: On units without
Free Hand, the auger and traction controls operate indepen-
dently, and the Free Hand icon set shown in Figure 2 is not
found on the dashboard.
Models with Free Hand™ Control: After engaging the trac-
tion control (left hand) and auger control (right hand), Free
Hand allows the operator to release the auger control, and for
the auger control to remain engaged until the traction control
is released. Free Hand models have the icon set shown in
Figure 2 on the dashboard.
2
Safety System Test (units without Free
Hand control)
DANGER
Amputation hazard
This snowthrower is equipped with several mechanical
safety systems designed to keep the operator safe while
using the unit. Check the operation of these systems regu-
larly using the safety system tests listed. If the unit fails to
operate as described, DO NOT operate it. See your autho-
rized dealer for service immediately.
Test 1 - Auger/Impeller Control
With the engine running:
• Press down on the auger control lever. (The auger/
impeller should rotate)
• Release the auger control lever. (The auger/impeller
must stop within 5 seconds)
Test 2 - Traction Drive Control
With the engine running and speed control in 1st gear:
• Press down on the traction control lever. (The unit
should move forward)
• Release the traction control lever. (The unit must stop)
7
en
English

Advertisement

loading

This manual is also suitable for:

1696925