Table of Contents
Advertisement
Laser 730&AT_Type A_US.qxd 15.3.18 16:36 ページ 9
SECTION E:
OPERATION
1. Open the Valve(s)
Open the valve(s) of the external fuel tank.
2. Start the Fuel flow
If using heater for the first time, press the red reset button in order to send fuel to
the fuel sump and release.
Note: Make sure there is no fuel leakage from the fuel line or joints.
Also make sure fuel tank is not too high. See installation instructions.
3. Plug in the Heater
Plug heater into a 120V AC electrical outlet. On digital indicator pre-set "Two
Dashes" will be showing.
Note: Do not connect to an outlet shared with other appliances.
4. Set Clock
Important: Clock on the heater must always be set to current time and day.
Note: "HOUR" or "MIN" button will change the time every one (1) unit. Holding the button
continuously will cause the time to change rapidly.
Note: In the event of a power failure (more than approx. 30 min.) all clock and day may be
cancelled.
5. Setting of the Time and a Day of the Week.
1) Current time is not set yet. (All signs light.)
Press the "▲MIN." button or "▼HOUR" button while in not operation. (Power switch is off.)
AM 12:00 is indicated on the display. (All signs except the colon are blinking.)
2) Setting of the current time
Press the "▲MIN." button to set minutes and press the "▼HOUR" button to set hours.
When pressing the "▼HOUR" button, the sign will change as follows.
"AM 12:00" ➞ "AM 1:00" ➞ ··· ➞ "AM 11:00" ➞ "PM 12:00" ➞ "PM 1:00" ➞ ··· "PM 11:00" ➞ "AM 12:00" ➞ ···
When pressing the "▲MIN." button, the sign will change as follows.
"AM 12:00" ➞ "AM 12:01" ➞ ··· ➞ "AM 12:59" ➞ "AM 12:00" ➞ ···
Press the "SET" button to complete the set of the current time.
BEFORE IGNITION
Reset Button
SET
ROOM
ON / OFF
MIN.
HOUR
AUTO
TIMER
SET
DAY
˚F / ˚C
CLEAR
SELECT
POWER SAVER
CHILD LOCK
Programmable System
9
Hide quick links:
Advertisement
Table of Contents
